In addition to the fuel pump again, have a new Tank O-ring to complete the installation.
If you opt for the project to install a new fuel pump in the car, we recommend that you work in a well ventilated area and take the fuel level to a minimum, preferably 1 / 8 tank or less. They are working with fuel, so keep safety in mind.
Jump Starter
Well opening the control panel to the fuse box and remove the fuse for the fuel pump. Start the machine and wait untilStable. Do this a few times, the car will not start. In this way, you are releasing the pressure of fuel in the fuel hose. Once the car stopped, put the fuse in. Make sure power is OFF before proceeding.
Raise your hood and disconnect the negative battery terminal. Open the cap and unscrew the gas pressure in the tank. Locate the plate pull access is usually in the trunk of your car and the wiring.Will be connected to the tubes to the plate. You must resolve the clamps and then remove the tubes. The gas is injected, if you need to remove rows as a rag. Remember, the pipe goes where. You can tape to remind you to use color. You should now be able to pull up to the tank plate access.
It is a fuel level sensor attached to it. You have to be careful all the assembly work out of the hole. After removing the level sensor, fuel pump, whiteOwners. Take a flat screwdriver and leave it open for the pump to release.
Now turn the fuel pump so that the bag will siphon out from under the owners of the pump. The spare pump is off and you can use the power to remove. There is a small clip that trap pockets to keep the stock fuel pump. You need the clamp to siphon out of the bag. With the same clip, set the bag on the new pump trap. Attach the strap to the pump and back into workthe media in the tank. Mount the tank access plate back up the hoses, and tighten the straps.
Connect the battery and turn to set the ignition to ON without a car. You can hear the pump for a second. What to do in such a way that the pipes do not leak.
Then you can put on the cover plate with a new O-ring. The last step is to put on the top of the tank again.
How to change your fuel pump drive
No comments:
Post a Comment